The aim of this study was to investigate experimental panels produced from mixture of agriculture wastes with mineral adducts under synthetic adhesive bonding process. In this respect, the effects of the two different mineral loading as reinforced additive (olivine and dolomite)...
Open access
Research Article10.9734/ajocs/2022/v11i119111
The quality performance of surface coatings are evaluated with emphasis on Microwave (Mw) irradiation, effects on both wood and oil modified alkyd-based varnish, separately. The surface pencil film hardness value of 2B (5 in metric) found for neat varnish coated linden and spruce...
Open access
Research Article10.9734/jalsi/2021/v24i530235
In these days, preparation of eco-friendly wood surface coating agents has become important topic for environmental concerns. In this study, an alternative surface coating formulations was prepared with adducts of oils of apricot kernel (A), sesame (S) and grape seed (G) were mix...
Open access
Research Article10.9734/ajb2t/2021/v7i330104
Aims: The three different above ground biomass components (branch, crown, bark) of European Beech (Fagus sylvatica) were evaluated, regarding energy and combustion properties. Study Design: The proximate, ultimate and calorific analysis conducted on components of European Beech t...
Open access
Research Article10.9734/ajocs/2021/v10i119082
Aims: An eco-friendly coating emulsion prepared with mixture of oils of sesame and grape seed and alkyd-based waterborne varnish. The prepared emulsion applied four different wood substrates (walnut, beech, cedar and fir) in order to be investigated for some selected surface prop...
Open access
Research Article10.9734/ajb2t/2021/v7i130090
Aims: It was investigated to produce gypsum-based experimental composite panels with red pine wood/rice straw particles in the mixture up to 60:40 (ratio) (w/w) in gypsum-water mixture. In this case, the additives could be observed more closely. Methodology: The red pine wood chi...
Open access
Research Article10.9734/irjpac/2019/v20i130126
It has been well established that many agricultural and forest residues might be useful as substitute for wood in forest products industry. In this study, low-value cotton processing residue (waste) mixture with red pine wood (fiber for Type 1 and chip for Type 2) were examined f...
Open access
Research Article10.9734/JALSI/2018/42028
The demand for new material sources is growing and there is an awakening interest in the use of forest residues. However, conifer needles are are still unexploited ones among forest residue. In most conifer growing areas, the needles basically serve as ground cover and can facili...
Open access
Research Article10.9734/JALSI/2017/37076
The influence of thermal treatment conditions on natural colour of Turkish hazelnut wood was investigated. It was realized that the elevated temperature and prolonged treatment time usually effects on darker tone on wood samples. However, the greatest lightness (DL) changes occu...
Open access
Research Article10.9734/JABB/2016/25111
It was realized that extended reaction time did not affect either kappa number or yield for both untreated and bio-treated ethanol-alkali jute pulps. The delignification ability of the ethanol-alkali organosolv system was somewhat better than the caustic soda system. However, the...
Open access
Research Article10.9734/ACSJ/2016/25914
The boards made from wood and secondary fibers appear to be well correlated secondary fiber/wood fiber proportions in terms of the behavior of the sound acoustic properties. However, boards were generally shown better acoustic (sound absorption) properties in high frequencies. Mo...
Open access
Research Article10.9734/JALSI/2017/37063
It was discovered that an increase in the proportion of secondary fibers has a negative impact on strength and thickness swelling (TS) properties of experimental boards. However, the highest MOR value of 20.0 MPa was found for type 1 board (C1) produced with a 90/10 Wood/Seconder...
Open access
Research Article10.9734/ACSJ/2016/27758
It was realized that both boric acid (BA) and secondary fibers (S) from Old Corrugated Container (OCC) negative impact on thickness swelling (TS) properties of boards in water. However, the highest Modulus of Elasticity (MOE) values of both type boards were found at 90/10 Wood/Se...
Open access
Research Article10.9734/ACSJ/2016/27757
It was realized that both boric acid (BA) and secondary fibers (S) from recycled newsprint papers had negative impact on thickness swelling (TS) properties of boards in water. The highest TS value of 48% was observed in both type boards that produced only from 100% secondary fibe...
Open access
Research Article10.9734/ACSJ/2016/27276
The objective of this work was to examine the suitability of poppy stalks for particleboard manufacturing. One-layer experimental panel with density of 0.45; 0.55 and 0.65 g/cm3 made from poppy stalks utilizing 8-10% urea-formaldehyde (UF) resin. The experimental boards were eval...
Open access
Research Article10.9734/JABB/2016/24977