Skip to content
Research Article Open access CC BY 3.0

Performance Evaluation of Photo and Biodegradation of Low Density Polyethylene Using Photodegradable Additive 4, 4’ Bis (Dimethylamino) Benzophenone (DMDAB) [Part – I]

Rajshree Vijayvargiya, A. K. S. Bhadoria, Ajay Kumar Nema

Current Journal of Applied Science and Technology · pp. 1736–1758 · Published 25 Feb 2014

10.9734/BJAST/2014/4779

Abstract

The additive 4, 4’ Bis (Dimethylamino) Benzophenone (DMDAB) is used as a photodegradable additive, which is commercially available and reported as UV active. DMDAB was melt blended with LDPE at three different formulations 1, 3 & 5 (w/w) % respectively in twin screw extruder. After blending with LDPE the performance of photo and bio degradation was evaluated. The films were evaluated for their mechanical, thermal, infrared spectroscopic analysis, and morphological characteristics. The results show that DMDAB can be used, as an effective photodegradable additive. The photo degradation rate of the additive is very high at lower concentration of DMDAB additive and the biodegradation was also proving that some low molecular weight species was formed during photo degradation, which is responsible for the 16% biodegradation after 50 days.

Photo degradation 4 4’ Bis (Dimethylamino) Benzophenone (DMDAB) Biodegradation low density Polyethylene (LDPE)

Cited by 1

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.