Skip to content
Research Article Open access CC BY 3.0

Ignition and Burning Rate of Water Hyacinth Briquettes

R. M. Davies, D. S. Abolude

Journal of Scientific Research and Reports · pp. 111–120 · Published 12 Feb 2013

10.9734/JSRR/2013/1964

Abstract

Aims: The study was conducted to investigate the effect of compaction pressure, binder proportion and particle size on ignition time and burning rate of fuel briquettes produced from a mixture of water hyacinth and plantain peel. Study design: The experimental design for this study was 5x3x4 Randomized Complete Block Design. Place and Duration of Study: The samples were collected from Port-Harcourt, Niger Delta, located between latitudes 4º 2´ and 6º 2´ North of the equator and longitudes 5º 1´ and 7º 2´ East of the Greenwich meridian, between Jan 2009 and March 2010. The laboratory work was conducted in the Mechanical Engineering Department, Ahmadu Bello University, Zaria, Kaduna State, Nigeria. Methodology: The experimental design for this study was 5x3x4 Randomized Complete Block Design. This study involved three particle sizes of dried and ground water hyacinth (D1, D2, D3) at levels 0.5, 1.6 and 4mm, pressure (P1, P2, P3, P4) at level 3.0, 5.0, 7.0 and 9.0MPa with plantain peels were used as binder (B1, B2- B3, B4, B5) in the ratio of 10, 20, 30 40 and 50% by weight of residue. They were arranged in Randomize Complete Block Design with three replications per experiment. Results: The effect of particle size, binder ratio and compaction pressure on burning rate of the briquettes varied from 0.92±0.03 g-1min (D1) to 2.66± 0.05 g-1min (D3), 1.57±0.11g-1min (B5) and 2.30±0.15g-1min (B1) and1.68±0.11 g-1min (P4) and 2.13±0.13 g-1min respectively. Conclusion: It could be concluded that Increased in compaction pressure, binder ratio and decreased in particle size caused decrease in the burning rate but elongated the ignition time of the briquettes.

Deforestation fossil fuel densification combustion atic plant and Nigeria

Cited by 21

Densification of raw and torrefied biomass: A review

Jimmy Eling, David K. Okot, Emmanuel Menya · Biomass and Bioenergy · 2024

Modelling the effect of compaction pressure on the densification of agricultural waste briquettes

U. A. Essien, P. K. Oke · African Journal of Science, Technology, Innovation and Development · 2019

Cleaner energy potential analysis for composite biomass residues from decentralized sawmills in Ghana- A case study for Oforikrom Municipality

Bright Amponsem, Edem Cudjoe Bensah, Julius Cudjoe Ahiekpor · Cleaner Engineering and Technology · 2022

Biomass densification pathways for India: An overview on technologies, characterization, testing, challenges and economics

Deepti, Deepanshu Awasthi, Kunwar Pal · Energy for Sustainable Development · 2026

Sustainable fuel production from water hyacinth: evaluation for cooking applications and resource mapping

Roshan Wathore, Ateeb Hamdan, Priya Badki · Biomass Conversion and Biorefinery · 2024

Showing 20 of 21 known citations — external sources report more than can currently be individually listed.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

21

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.