Skip to content
Research Article Open access CC BY 4.0

Design of Adaptive Control System Based on Model Reference Stick Slip Vibration

Huang Xun, Yang Xiao, Li Jianghong, Li Changhao

Current Journal of Applied Science and Technology · pp. 1–11 · Published 2 Jan 2018

10.9734/CJAST/2017/38422

Abstract

The stick-slip vibration is a common vibration mode of the drill string system during the drilling and it is extremely destructive. The drilling efficiency will be greatly reduced, if the drill gets a bit damaged and the drill rod breaks when the stick-slip vibration occurs. In order to solve this problem, a two-degree-of-freedom focused mass model was established. The controller based on the model reference adaptive control method was designed. The simulation experiment was completed to prove the rationality of the established stick-slip vibration model and the correctness of the control method. The control equipment was developed and the tests above on the well were completed. The experimental results shows that the designed stick-slip vibration control system has validity and stability.

Stick-slip vibration of drill string adaptive control feedback control control system mechanical model model reference

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.