Skip to content
Research Article Open access CC BY 3.0

Experimental Results for Concentricity in Wire Coating Processes

Bekir Cirak

Current Journal of Applied Science and Technology · pp. 3976–3985 · Published 26 Jul 2014

10.9734/BJAST/2014/11893

Abstract

The wire coating thickness and quality depend on the wire speed, polymer viscosity, polymer melt temperature and the gap between the wire and exit end of the die. In this paper, results of experimental investigation are presented by comparing the coating quality on galvanized mild steel wire using EP 58 PVC molten is used as the coating material in a wire coating extrusıon unit at different extruder temperatures and extruder speeds. The coating thickness and quality are also discussed for different wire speeds of up to 15 m/s.

Wire coating extruder coating thickness PVC extrusion

Cited by 3

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

3

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.