Skip to content
Research Article Open access CC BY 4.0

Experimental Study Corrosion Parameters of Copper as an Eco-Friendly Heat Collector for Solar Water Heaters

J. C. Morka, O. C. Molua, A. Egheneji, M. Edobor, F. C. Ighrakpata

Journal of Geography, Environment and Earth Science International · pp. 49–55 · Published 26 May 2023

10.9734/jgeesi/2023/v27i5686

Abstract

The corrosion behaviour of copper as a solar collector material was adequately simulated in tests in a solar water heating system. The weight loss technique of corrosion determination was used under exposure conditions ranging from slightly acidic to alkaline. Uniform corrosion was observed and corrosion rates; calculated estimates of the life of a typical collector made of copper were evaluated and found to be below 0.0254 mmpy and the subsequent evaluation of the life of a 3mm thick pipe shows lives of over a hundred years under the varying exposure conditions. A significant fact is that uniform corrosion took place over the period of the test.

Corrosion copper heat-collector water-heaters eco-friendly environment

Cited by 1

Copper as a catalyst: the strategic role of mineral resources in the clean energy transition

Nurcan Kilinc, Abdulkadir Barut, Mustafa Kevser · Studies in Economics and Finance · 2025

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.