Electrostatic Induction Spray-charging System (Embedded Electrode) for Knapsack Mist-blower

Abstract

The introduction of electrically charged sprays in agricultural application has become inevitable for better control on droplet transference with reduced drift with less spray chemical requirements.  The study was under taken to develop an electrostatic induction spray charging system as attachment to knapsack mist-blower. A high voltage generator was fabricated on the basis of Cockcroft-Walton voltage multiplier principle with input of 6 V DC battery. A self-atomizing hydraulic nozzle was developed to deliver the droplet spectrum required for effective electrostatic charge induction.  The prototype was evaluated for charge to mass ratio (mC. kg-1) at five electrode potentials (1 kV, 2 kV, 3 kV, 4 kV and 5 kV) at four electrode placement positions from atomization zone (0, 5, 10 and 15 mm). The charge mass ratio (CMR) value of spray cloud was measured using Faradays Cage at five positions from nozle tip (50, 100, 150, 200 and 250 cm). The electrode voltage potential at 5 kV at its position 5 mm from the atomization zone shown the maximum CMR value of 1.088 mC.kg-1. In contrast with commercial system (ESS-MBP90) it was observed that except at 50 cm distance, the developed charging system, at 4 kV and 5 kV, surpassed commercial system in CMR from 100 cm to 250 cm distances. The droplet spectrum of the developed system was analysed and observed that the size of droplets were 100 to 200 µm.  The developed system found to be cost effective and significantly consistent over the commercial one.