Skip to content
Research Article Open access CC BY 4.0

Development of a Sawdust Fluidized Bed Gasifier: Design and Fabrication

O. R. Akinyemi, N. G. Olaiya

Journal of Engineering Research and Reports · pp. 1–11 · Published 16 Jan 2020

10.9734/jerr/2019/v9i417023

Abstract

Aims: This research involves the development of a sawdust fired fluidized bed reactor for the production of synthetic gas for domestic cooking. Study Design: A sawdust fired fluidized bed reactor using AutoCAD inventor. Place and Duration of Study: Department of Mechanical Engineering, Federal University of Technology, Akure Ondo state Nigeria. Methodology: The reactor consists of a hopper, rolled mild steel plate frame lined with clay which forms the frame, air distributor plate and five radially spaced tuyeres. The reactor is fed with pelletized sawdust, retain heat within it and maintain a temperature of 50⁰C at the external surface to minimize burns. Results: Air was forced into the plenum, after which the air distributor plate evenly distributed jets of air in the bed resulting in complete and incomplete combustion. Combustible gas was produced after 30 minutes and used to boil water. Conclusion: The sawdust fired fluidized bed reactor is recommended for domestic household use.

Sawdust fluidized designed fabrication pyrolysis cooking gas biomass.

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.