Skip to content
Research Article Open access CC BY 4.0

Preparation and Characterization of Activated Carbons from Bitter Kola (Garcinia kola) Nut Shells by Chemical Activation Method Using H3PO4; KOH and ZnCl2

Kuete Tiotsop Idris-Hermann, Tchuifon Tchuifon Donald Raoul, Doungmo Giscard, Anagho Solomon Gabche

Chemical Science International Journal · pp. 1–15 · Published 31 Aug 2018

10.9734/CSJI/2018/43411

Abstract

Aims: Investigate the changes occurring in the composition of Garcinia kola nut shell after an activation process, especially the characteristics of the chemically activated carbons (ACs) obtained. Study Design: Determine of the physicochemical properties of the prepared ACs using optimized experimental data. Place and Duration of Study: Research Unit of Noxious Chemistry and Environmental Engineering, Department of Chemistry, Faculty of Science, University of Dschang, between February 2016 and March 2018. Methodology: Garcinia kola nut shell (bitter kola nut shell) were used to prepare ACs by chemical activation using H3PO4, KOH and ZnCl2 using the carbonization temperatures 400, 450 and 500°C and the different impregnation ratios 1/1 and 2/1. The effects of the composition of the components on the iodine number and iodine methylene blue number of the ACs were investigated. The best ACs were selected after optimization of the experimental data obtained in the laboratory. Results: Increase in carbonization temperature from 400°C to 500°C led to a decrease in the iodine number and an increase of in burn-off. For the production of ACs, the optimum temperature was found to be 400°C for 1 hour heating, with impregnation ratio of 1/1 by KOH, ZnCl2 ACs and 2/1 for the H3PO4 AC. Thermo-gravimetric analysis of the raw material was carried out to confirm the thermal stability of the ACs obtained at the optimum temperature of 400°C. The functional surfaces of the ACs and raw materials were studied by Bohem titration, pH, pzc, and FT-IR techniques. SEM analysis illustrates an irregular and heterogeneous surface morphology with a developed and fragmented porous structure of various sizes. Powder X-ray diffraction analysis showed that the raw material and ACs prepared are essentially amorphous. Conclusion: Chemical activation is one of the appropriate methods that can be used to obtain new ACs. The maximum iodine number of the ACs was obtained at carbonization temperature of 400°C for a period of 1 hr, with impregnation ratios 2/1 and 1/1.

Garcina kola shell Activated Carbons (ACs) chemical activation iodine number burn-off amorphous

Cited by 20

ADSORPTION OF METHYLENE BLUE ONTO ACTIVATED CARBON DEVELOPED FROM BAOBAB FRUIT SHELL BY CHEMICAL ACTIVATION: KINETIC EQUILIBRIUM STUDIES

Radhia Nedjai, Ma’an Fahmi Rashid Alkhatib, Md Zahangir Alam · IIUM Engineering Journal · 2021

Agro-waste-based functionalized mesoporous activated carbon for the effective remediation of Cr (VI) from wastewater

Mahmuda Hakim, Sharmina Faruk, Mohammad Mahbub Kabir · Biomass Conversion and Biorefinery · 2024

Activation of biomass (cola nut shell) with KOH and K2C2O4: The distinct influence on evolution of volatiles and pore structures of activated carbon

Félix Mérimé Bkangmo Kontchouo, Yuchen Jiang, Jingyi Liang · Journal of the Energy Institute · 2023

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

20

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.