Skip to content
Research Article Open access CC BY 3.0

Performance Evaluation of a Low Heat Rejection Diesel Engine with Mohr Oil Based Biodiesel

T. Ratna Reddy, M. V. S. Murali Krishna, CH. Kesava Reddy, P. V. K. Murthy

Current Journal of Applied Science and Technology · pp. 179–198 · Published 7 Jun 2012

10.9734/BJAST/2012/1254

Abstract

Aim: Investigations were carried out to evaluate the performance of a high grade low heat rejection (LHR) diesel engine with air gap insulated piston, air gap insulated liner and ceramic coated cylinder head (ceramic coating of thickness 500 microns was done on inside portion of cylinder head] with different operating conditions (normal temperature and pre-heated temperature) of Mohr oil based bio-diesel (MOBD) with varied injection pressure and injection timing. Study Design: Performance parameters of brake thermal efficiency, exhaust gas temperature and volumetric efficiency were determined at various values of brake mean effective pressure (BMEP). Methodology: Exhaust emissions of smoke and oxides of nitrogen (NOx) were recorded at different values of BMEP. Combustion characteristics at peak load operation of the engine were measured with TDC (top dead centre) encoder, pressure transducer, console and special pressure-crank angle software package. Results: Conventional engine (CE) showed deteriorated performance with biodiesel operation, while LHR engine showed improved performance at recommended injection timing and pressure of 27°bTDC (before top dead centre) and 190 bar respectively. The performance of both version of the engine improved with advanced injection timing and at higher injection pressure when compared with CE with pure diesel operation. The optimum injection timing was 31°bTDC for CE while it was 30°bTDC for LHR engine using biodiesel operation. It was also observed that peak brake thermal efficiency increased by 14%, volumetric efficiency decreased by 8%, smoke levels decreased by 6% and NOx levels increased by 47% with MOBD operation on LHR engine at its optimum injection timing, when compared with pure diesel operation on CE at 27°bTDC.  

Mohr oil esterification LHR engine fuel performance emissions combustion characteristics

Cited by 9

EXPERIMENTAL INVESTIGATION ON THERMAL BARRIER-COATED DIESEL ENGINE USING ANTIOXIDANT-DOPED ORANGE PEEL OIL BIODIESEL

R. MEENAKSHI REDDY, RAVINDRA PRATAP SINGH, JATINDER KAUR · Surface Review and Letters · 2024

Thermal and Structural Analysis of Piston by Ansys

Department of Mechanical Engineering, Gokaraju Rangaraju Institute of Engineering and Technology, Bachupally, Hyderabad (Telangana), India., Nallapu Sateesh · International Journal of Inventive Engineering and Sciences · 2024

Exhaust Emissions Reduction from Neat Biodiesel Operated Diesel Engine Using Catalyst Coated Piston and Antioxidant Additive

Silambarasan Rajendran, Senthil Ramalingam, Munusami Viswanathan · SAE Technical Paper Series · 2018

A comparative study of performance and emission characteristics of neat biodiesel operated diesel engine: a review

Silambarasan Rajendran · Journal of Thermal Analysis and Calorimetry · 2020

Optimization of Daniel Cam Engines

Viorel Badescu · Studies in Systems, Decision and Control · 2017

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

9

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.