MATLAB Combined with APDL Simulation in Reference to Y-shaped Steel Turnout Pipe
Advances in Research · pp. 163–167 · Published 18 Sep 2024
10.9734/air/2024/v25i51148Abstract
This paper takes a symmetric Y-shaped steel bifurcation pipe as an example, uses ANSYS finite element analysis software to carry out parametric modeling, grid division and load application, combined with MATLAB software to carry out operation processing, and finally analyzes the results and draws a conclusion.
Cited by 0
No indexed citations yet.
Related research
- ANSYS Simulation of Loads Experienced by the Peduncle of a Design of Robotic Fish — shares topic coverage
- Finite Element Analyses of Automobile Crankshaft Using ANSYS — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.