Differential Active Balun Design for WiMAX Applications
Frederick Ray I. Gomez, John Richard E. Hizon, Maria Theresa G. De Leon
Journal of Engineering Research and Reports · pp. 1–8 · Published 22 Apr 2019
10.9734/jerr/2019/v4i416908Abstract
The paper presents a design and simulation study of a differential active balun circuit implemented in a standard 90 nm complementary metal-oxide semiconductor (CMOS) process. The active balun design is intended for Worldwide Interoperability for Microwave Access (WiMAX) applications operating at frequency 5.8 GHz and with supply voltage of 1V. Measurements are taken for parameters such as gain difference, phase difference, and noise figure. The differential active balun design achieved gain difference of less than 0.23 dB, phase difference of 180° ± 3.4°, and noise figure of 9.78 dB, which are comparable to past active balun designs and researches. Lastly, the design achieved a low power consumption of 3.6 mW.
Cited by 0
No indexed citations yet.
Related research
- Gilbert-Cell Mixer for WiMAX Applications — shares topic coverage
- Design of Common-Source/Drain Active Balun Using 90nm CMOS Technology — shares topic coverage
- Design of Common-gate with Common-source Active Balun for WiMAX Receiver Front-end — shares topic coverage
- AC Analysis of Differential Active Balun Topology — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.