Skip to content
Research Article Open access CC BY 4.0

Removal of Dyes from Wastewater of Artisanal Dyeing Plants by Adsorption in a Fixed Bed Column of Deactivated Lichens

Kouassi Kouadio Dobi-Brice, Yacouba Zoungranan, Dje Daniel Yannick, Ekou Lynda, Ekou Tchirioua

International Research Journal of Pure and Applied Chemistry · pp. 1–11 · Published 1 Jul 2021

10.9734/irjpac/2021/v22i530405

Abstract

Aims: Pollution by wastewaters from various urban activities such as artisanal dyeing plants is a real problem for developing countries. The treatment of wastewater by the adsorption method is carried out by means of less expensive and available adsorbent media. Two techniques of the adsorption method are possible: adsorption in continuous mode (column adsorption) and adsorption in discontinuous mode (batch adsorption). The choice of the continuous adsorption technique is justified by its ability to process large volumes of solutions. In this study, dyes contained in wastewater from artisanal dyeing plants were removed by continuous adsorption in a fixed-bed column of deactivated lichen biomass (Parmotrema dilatatum). Study Design: Random design Place and Duration of Study: Laboratory of Thermodynamics and Environmental Physico-Chemistry (University Nangui Abrogoua, Ivory Coast) between May 2020 and October 2020. Methodology: Four (4) categories of wastewater were collected in artisanal cotton and leather dyeing plants through two municipalities of the city of Abidjan, economic capital of Ivory Coast. Two (2) wastewaters colored in blue from dyeing of cotton boubous and jeans and two (2) wastewaters colored in red from dyeing of leather jackets and bags. These wastewaters were treated through the fixed bed column of deactivated lichens. The column feed rate was set at 0, 07 L.min-1 and the adsorbent bed mass at 100 g. Results: The study showed that, regardless of the nature of the dyed object and regardless of the target dye, the amount of dye adsorbed was better with waters of higher initial concentration. Thus the best amount of adsorbed dye is 44.444 mg.g-1 and the best removal rate is 97.9%. These values are obtained with the red wastewater of bags (RWB) treatment which was the most concentrated wastewater. Conclusion: Good efficiency of deactivated lichen bed as adsorbent for the in situ removal of dyes from wastewater by continuous adsorption.

Wastewater continuous adsorption dyes dye plant artisanal lichens fixed bed column

Cited by 1

1 citation reported by external sources — individual citing-article records aren't available to list yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.