Development of an Indoor Line Scanning System for Photovoltaic Modules Performance Characterization

Abstract

Uganda’s interest in using solar energy for various applications began 20 years ago. However, there have been numerous reports by the public over the poor performance of the photovoltaic (PV) modules during their operations. This study determined the performance of selected PV modules openly sold in the Ugandan markets. The low-cost indoor line scanning system developed using locally available materials was used to assess the performance of each of the solar cells in the PV module by determining their photogenerated currents. In addition, the electrical characteristics of the PV modules were determined using the outdoor characterization method, which assumed the actual operation of the PV modules under direct sunlight. From the indoor line scans, the percentage of performing solar cells in the three PV modules of single-crystalline silicon (c-Si), multi-crystalline silicon (mc-Si), and amorphous silicon (a-Si) technologies were determined as 79%, 61%, and 95% respectively.  The outdoor characterization results revealed that the c-Si, mc-Si, and a-Si PV modules had measured maximum power outputs of 18.5 W, 19.0 W, and 18.9 W, respectively and these were lower than the rated power values of 20 W. The line scan results had a direct relationship with the measured power output of the PV module, which implied that solar cells mismatch, affected the performance of the PV modules by lowering their performance. This developed testing system is affordable for developing countries with limited testing systems and would in the long run contribute to significant increase in the deployment of PV technology in Uganda since only performing PV modules would be allowed into the open market.