Skip to content
Research Article Open access CC BY 3.0

Characterization of Plasma Sprayed Pure Red Mud Coatings: An Analysis

Alok Satapathy, Harekrushna Sutar, Subash Chandra Mishra, Santosh Kumar Sahoo

Chemical Science International Journal · pp. 151–163 · Published 23 Mar 2013

10.9734/ACSJ/2013/3218

Abstract

The characteristics of plasma sprayed pure red mud coatings have been investigated.The red mud was collected as a waste from aluminium production. In order to understand the coating characteristics, pure red mud was plasma coated. After plasma spraying, the coated materials have been subjected to series of tests to determine coating thickness, adhesion strength, micro structural characterization of cross section, X-ray diffraction and coating deposition efficiency. Plasma spraying is done at 200, 250, 300 and 400 ampere current. Torch input power is maintained at 6,9,12 and 16 kW. The coating samples chose are dimension 50mm×25mm×2mm. Available substrates are made of aluminium, copper, mild steel and stainless steel.  

Plasma spraying red mud coating coating characteristics

Cited by 17

Feasibility of RF Sputtering and PIIID for production of thin films from red mud

Maria Lúcia Pereira Antunes, Nilson Cristino da Cruz, Adriana de Oliveira Delgado · Materials Research · 2014

Erosion behavior of marble dust-coated mild steel substrates

Sandip Kumar Nayak, Alok Satapathy, Sisir Mantry · Journal of the Brazilian Society of Mechanical Sciences and Engineering · 2022

Wettability, Thermal and Sliding Behavior of Thermally Sprayed Fly Ash Premixed Red Mud Coatings on Mild Steel

Harekrushna Sutar, Birupakshya Mishra, Rabiranjan Murmu · Materials Sciences and Applications · 2020

Thin films produced on 5052 aluminum alloy by plasma electrolytic oxydation with Red Mud-containing Electrolytes

Lívia Sottovia, Maria Lúcia Pereira Antunes, César Augusto Antonio · Materials Research · 2014

Optimizing wear analysis of plasma sprayed Linz-Donawitz slag-Al 2 O 3 coatings using experimental design and neural network

Pravat Ranjan Pati, Alok Satapathy, Gaurav Gupta · Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology · 2022

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

17

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.