Skip to content
Research Article Open access CC BY 3.0

Conversion of Low Density Polyethylene (LDPE) and Polypropylene (PP) Waste Plastics into Liquid Fuel Using Thermal Cracking Process

Moinuddin Sarker, Mohammad Mamunor Rashid, Md. Sadikur Rahman, Mohammed Molla

International Journal of Environment and Climate Change · pp. 1–11 · Published 29 Feb 2012

10.9734/BJECC/2012/994

Abstract

In every sector of the world today energy is essential. Energy has many forms such as electricity, transportation fuel and so on. A large amount of energy is produced from crude oil, which is used to produce petroleum and petroleum to produce daily usable plastics. The solution to the above mentioned problems can be solved through the utilization of the new develop technology. This new developed technology will remove these hazardous waste plastics from the environment and convert them into eco friendly liquid fuel. The process is used to convert these waste plastics into liquid fuel creates no harmful emissions and can be produced at a very little overall cost. The thermal process utilized to break down the hydrocarbon chains of the polymers and convert them into liquid fuel. A Steel reactor with temperature range from 100 ºC to 400 ºC is utilized for the plastic thermal degradation process. The process yield about 80-90% liquid product. The experiment is conducted under a fume hood and open air system, no vacuum process is applied in this particular thermal cracking process.

Renewable energy thermal cracking fuel environment waste plastic hydrocarbon gas

Cited by 35

Liquid Products from Ternary, Quaternary, and Quinary Co-pyrolysis of Waste Plastics and Residual Fuel Oil: Characterization and Potential Applications

P. Kasar, L. Songachan, M. Ahmaruzzaman · Journal of Inorganic and Organometallic Polymers and Materials · 2024

A Review of Plastic Pollution; Conventional and Recent Bioremediation Technologies

C. Udekwu, Uchechukwu Chidiebere Francis, M. Ojetunde · Journal of Digital Food, Energy & Water Systems · 2024

Separation of plastic wastes using froth flotation - An overview.

O. Kökkılıç, S. Mohammadi-Jam, Peng-Bo Chu · Advances in Colloid and Interface Science · 2022

Co-treatment of PVC and used LCD panels in low-temperature subcritical water: Enhanced dechlorination and mechanism

Fu-Rong Xiu, Ke Zhou, Xuan Yu · Chemical engineering research & design · 2021

Characterization of liquid products obtained from catalytic co-cracking of polypropylene waste and residual fuel oil

P. Kasar, M. Ahmaruzzaman · Journal of Scientific & Industrial Research · 2021

Characterization of waste plastic oil as biodiesel in IC engines

S. L. Kumar, S. Radjarejesri, R. Jawahar · 2020

Utilization of plastic waste into fuel (fuel oil) in Namo Bintang Village, Deli Serdang Regency

M. S. Yeanny, R. Sinaga, I. Nurwahyuni · ABDIMAS TALENTA: Jurnal Pengabdian Kepada Masyarakat · 2019

Production of Bio-Fuel From Plastic Waste

J. Joseph, F. T. Josh · Journal of Physics, Conference Series · 2019

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

35

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.