Skip to content
Research Article Open access CC BY 4.0

Removal of Nickel from Plating Wastewater Using the Magnetic Flocculant PG-M

Le Thi Xuan Thuy, Nguyen Thi Sao Mai, Ho Hong Quyen, Mikito Yasuzawa, Tran Xuan Vu

Chemical Science International Journal · pp. 1–9 · Published 19 Mar 2018

10.9734/CSJI/2018/39902

Abstract

In this study, a new kind of magnetic particle functionalized biopolymer (PG-M) was applied to remove nickel from plating wastewater. The key parameters of pH, adsorption time, the mass of adsorbent, and shaking speed were investigated to optimize conditions. Batch experiments were conducted with actual samples collected from a manufacturer having an initial nickel concentration of 143.73 mg/L at pH 5. The highest removal efficiency of Ni2+ ions was greater than 99% when 1 g/L of the PG-M material was added to the solution (pH=10) and stirred at 200 rpm for 20 min. The desorption of this adsorbent was performed in a 0.1 M solution of HCl and the removal efficiency of Ni2+ ions unchanged after nine cycles. The Ni2+-loaded PG-M magnetic flocculant was easily separated from the solution by an external magnet.

Heavy metal nickel adsorption PG-M

Cited by 1

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.