Skip to content
Research Article Open access CC BY 4.0

Gamma-radiation-induced HDPE/Wood Composite: Studies of Morphological, Mechanical and Thermal Properties of the Composites

Babacar Niang, Diene Ndiaye, Moustapha Lô Kholl, L. Y. El Hadj Babacar, Abdou Karim Diallo, Ansou Malang Badji

Chemical Science International Journal · pp. 1–12 · Published 1 Nov 2017

10.9734/CSJI/2017/37423

Abstract

Wood-polyethylene composites (WPEC) have been prepared with high density polyethylene (HDPE) matrix with pine wood, using maleic anhydride polyethylene (MAPE) as coupling agent and gamma irradiated.  This paper discusses the behavior of the composites after exposure to various gamma irradiation doses (5 – 175 kGy) in the presence of oxygen. The dependence of mechanical properties on the integral dose for a constant dose rate of 4.8 kGy/h confirms the influence of the irradiation. The main objective of this study was also to examine the potential benefits of gamma irradiating WPEC in order to enhance some physical properties of WPC, namely morphological and thermal properties. The tensile and flexural modulus increased with dose level. The fracture surfaces of the composites show a noticeable difference with the increase in the dose rate.  The fracture surfaces of composites exhibited clear difference in failure with increasing the dose rate. Meanwhile, the thermal stability was found to increase with increasing irradiation dose as shown by the percentage loss in weight at different decomposition temperatures and the temperatures of the maximum values of the rate of reaction. Examination of the fracture surfaces of composites revealed a distinct difference in failure between irradiated and non-irradiated surfaces.

Gamma irradiation composite morphological thermal mechanical properties

Cited by 13

Introduction to Wood Polymer Composites

R. Ruban, H. Mohit, P. Ramesh · Composites Science and Technology · 2021

Effect of gamma-ray on the physical, morphological and biological durability properties of Abies wood composite

Mohammad Hamed Shojaie, Amir Hooman Hemmasi, Mohammad Talaeipour · Radiation Physics and Chemistry · 2023

Effect of gamma-ray and melt flow index of polypropylene on the properties of the lignocellulosic composite

Mohammad Hamed Shojaie, Amir Hooman Hemmasi, Mohammad Talaeipour · Radiation Physics and Chemistry · 2020

Exploring the impact of gamma rays and electron beam irradiation on physico-mechanical properties of polymers & polymer composites: A comprehensive review

Neha Bansal, Sanjiv Arora · Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms · 2024

Study of the Thermal, Rheological, Morphological and Mechanical Properties of Biocomposites Based on Rod-Of Typha/HDPE Made up of Typha Stem and HDPE

Babacar Niang, El Hadj Babacar Ly, Abdou Karim Diallo · Advances in Materials Physics and Chemistry · 2018

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

13

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.