Design of Solar Blind Photodetectors for Communication with Green Signal (λ= 0.532µm) in Space. Part II
Samson Mil’ shtein, Dhawal Asthana
Journal of Engineering Research and Reports · pp. 20–25 · Published 2 Dec 2020
10.9734/jerr/2020/v19i217227Abstract
The areas of Free Space Optical (FSO) communication and high-speed Visible Light Communication (VLC) offer potential for very high-speed data transmission. Favorable attributes including high frequency and wider bandwidths that can enable transmission speeds of the order 100Gb/s, associated with the visible region of the electromagnetic spectrum make it preferable for allowing communication among satellites and ground stations, under-water communication, etc. However, limitations associated with spectral absorption characteristics of the propagating media have stymied further development of such technologies. Aims: Commercial lasers operating in red, green and blue lights combined with three photodetectors, each sensitive to selected wavelengths (colors) present basics of long-distance optical communication system. The current study (Part II) depicts the design and operation of a solar-blind photodetector capable to work explicitly with green wavelength of 532nm. Study Design and Results: The structure of the solar-blind photodetector consists of two sections made of InxGa1-xN (Indium Gallium Nitride) heterostructure, (where x denotes the mole fraction)-a filter and a double barrier tunneling diode. The topmost approximately 1µm thick section acts as a filter and as a p-i-n solar cell providing the required voltage bias to the photodiode. The filter with Eg (Energy Band Gap)=2.33eV absorbs all photons having wavelengths shorter than 532nm. The double barrier tunneling photodiode which comprises the lower section operates with Eg=2.28eV. It consists of an n-type lightly doped quantum well having a width of 2.5nm housed between two lightly doped barriers of 10nm thickness. The 0.12µm topmost and bottom regions of the photodiode are doped with p and n (2×105cm-3) type impurities, respectively. The illuminated cross-section area of the device is finalized at 1mm2.
Cited by 0
No indexed citations yet.
Related research
- Synergistic Use of Remote Sensing for Snow Cover and Snow Water Equivalent Estimation — shares topic coverage
- Mapping of Geomorphological Features and Surface Sediments in Nekhel Area, Sinai Peninsula, Egypt Using Integration between Full-polarimetric SAR (RADARSAT-2) and Optical Remote Sensing Data — shares topic coverage
- Investigation of the Optical and Electrical Properties of Copper Telluride and Cadmium Telluride Thin Films Using Electrodeposition Technique — shares topic coverage
- Development of a Low Cost, AI Enhanced IoT Home Automation System with Adaptive Energy Management and Predictive Maintenance — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.