Skip to content
Research Article Open access CC BY 4.0

Influence of Temperature and Time of Exploitation of Welded Joints in the Operation of Static and Dynamic Loads

I. Camagic, P. Zivkovic, S. Makragic, M. Radojkovic, A. Radovic

Current Journal of Applied Science and Technology · pp. 1–12 · Published 10 Sep 2016

10.9734/BJAST/2016/28339

Abstract

Shown in this paper is the analysis of the effects of exploitation duration and temperature on the measure of fracture resistance of constituents of a welded joint between new and exploited low-alloyed Cr-Mo steel A-387 Gr. B subjected to static and variable loads. Exploited parent metal is a part of a reactor mantle which was working for over 40 years and is in the damage repair stage, i.e. part of its mantle is being replaced with new material. Tensile curves necessary for stress analysis were determined, along with material strength properties and Wohler’s curves were drawn, in other words permanent dynamic strength was determined as material resistance to crack initiation, on room and working temperature. Based on test results, the analysis of fracture resistance represents the comparison of values obtained for characteristic areas of the welded joint and justifiability of the selected welding technology.

Welded joint crack yield stress tensile strength permanent dynamic strength.

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.