Simulation of Convection Flow and Sensitivity Analysis of Model Parameters of Evacuated Glass Tube Solar Water Heater

Abstract

The water-in-glass evacuated collectors are made up of parallel circular tubes. They are installed with some inclination angle to the horizontal. The thermal performance of water-in-glass evacuated tube solar water heater heavily depends on weather conditions. The analysis of the sensitivity of the model parameter and weather conditions on heat transfer process is extremely important to install a solar water heater system in order to achieve its maximum efficiency. The evaluation of the sensitivity of the system parameters is done by considering one parameter after another while keeping the remaining fixed. Further to the analysis of the heat transfer process, the average heat transfer coefficient and the average natural circulation flow rate are calculated. The fluid flow is assumed to be unsteady, two-dimensional, laminar and incompressible. The heat and fluid flow are analyzed using the Navier-Stokes equations and temperature equation for an incompressible fluid, subject to density variation with temperature. The discretization of the governing equations is done by Finite Volume Method (FVM). The Open FOAM computational fluid dynamic software with PISO-SIMPLE algorithm is used for the simulation. The results show that the heat transfer process is improved when there is a moderate level inclination angle. Further, it is found that when the ratio of tube length to diameter is high, the heat transfer process is improved. The solar radiation input highly affects the performance of a solar water heater. The cold-water inlet temperature does not directly affect the buoyancy induced flow, but it influences the temperature gain. The angle of the solar rays vary within the daytime, however it does not affect the performance of the solar water heater since an evacuated-tube has a circular absorbing surface, it passively tracks the sun throughout the day.  These results recommend using moderate level tube inclination angle and high  ratio to improve the performance of a solar water heater.