Skip to content
Research Article Open access CC BY 4.0

Off-centered Ball Resolution Through Multi-hole Process Plate Implementation at Wirebond Process

J. Pulido, F. R. Gomez, E. Graycochea Jr.

Journal of Engineering Research and Reports · pp. 45–50 · Published 15 May 2021

10.9734/jerr/2021/v20i717340

Abstract

With the continuous trend of new technologies in semiconductor manufacturing assembly, challenges and issues are unavoidable. This paper presents the modification and improvement done on the process plate design to eliminate the bouncing effect of the silicon die that leads to off-centered ball (OCB) reject during the formation of wire on a quad flat no-leads (QFN) device. The panel type single-row process plate cannot totally vacuum the warped leadframe and this is resulting to off-centered ball. Through changing the panel type single-row process plate to panel type multi-hole process will have a strong vacuum sucked underneath the leadframe and eliminates the occurrence of off-centered ball. Future works could use the improved process plate design for devices of similar configuration.

Assembly bond ball process plate wirebond

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.