Skip to content
Research Article Open access CC BY 4.0

Addressing the Broken Wire Issue during the Assembly Manufacturing of QFN Leadframe Device

Raymond Albert A. Narvadez, Freddie B. Folio, Frederick Ray I. Gomez, Jonathan C. Pulido

Journal of Engineering Research and Reports · pp. 97–103 · Published 23 Jun 2021

10.9734/jerr/2021/v20i817363

Abstract

The integrity of the assembly wirebond process’ 2nd bond poses a big challenge for semiconductor manufacturing of quad-flat no-leads (QFN) devices, particularly on multiple wires on a lead. These devices are vulnerable to induce or obtain broken wire at heel defect. This type of defect is an abnormality in the formation of the stitch, mostly a crack or fracture seen on the facade of the stitch. Normally, it happens when there is too much vibration or transfer of ultrasonic generator (USG) power combined with high bonding force on 2nd bond. In the case of leads with common wires, broken wire at heel could also happen through excessive USG application resulting to transfer of resonance on adjacent wires. This paper presents a better understanding and analysis done to provide an adequate and appropriate solution to broken wire at heel issue.

Assembly broken wire QFN semiconductor packaging USG wirebond

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.